Table 39: Interface Support for 40-Gigabit Ethernet QSFP+ Transceivers for the QFX
Series (continued)
Specifications
Standards
Compliance
JNP-QSFP-4X10GE-LRProduct SKU numberJuniper Networks
proprietary 4X10G-LR
QFX5100-24Q
QFX5100-48S
QFX5100-48T
QFX5100-96S
Supported models
9.95328 +/- 20 ppm
10.3125 GBd +/-100 ppm
Signaling rate, each lane
(range)
12-ribbon single mode fiber-cable with female MPO/APC connector
NOTE: See“Cable Specifications for QSFP+ and QSFP28 Transceivers”
on page 147.
Connector type
4Fiber pairs
1260 nm to 1355 nmTransmit and receive lane
wavelength
-6.5 dBmAverage transmit launch
power, each lane (minimum)
0.5 dBmAverage transmit launch
power, each lane (maximum)
-14.4 dBmAverage receive power, each
lane (minimum)
-1.5 dBmAverage receive power, each
lane (maximum)
-12.6 dBmReceiver sensitivity (OMA),
each lane (maximum)
-10.3 dBmStressed receiver sensitivity
(OMA), each lane
(maximum)
AvailableDOM support
9/125 µmCore/cladding size
2 m (6.56 ft) to 10 km (6.21 miles)Operating distance
121Copyright © 2016, Juniper Networks, Inc.
Chapter 8: Port and Interface Specifications
To Next Page
Loading...
