NOTE: The switch powers on as soon as power is provided to the power
supply. There is no power switch on the device.
10. Verify that the IN and OUT LEDs on the power supply are lit green and are on steadily.
CAUTION: A system reboot with Routing Engine FPGA version 7.1 might
not successfully boot the Junos OS software. In case of a system reboot
failure, you need to power cycle the switch. To check the current FPGA
version, issue the show chassis firmware command.
Related
Documentation
• DC Power Supply in a QFX5100 Device on page 49
• DC Power Supply LEDs on a QFX5100 Device on page 62
Copyright © 2016, Juniper Networks, Inc.178
QFX5100 Switch Hardware Guide
To Next Page
Loading...
