Junos Snapshot Installer - (c) Juniper Networks 2013
Reboot
Install Junos Snapshot [14.1X53-D11_vjunos.61]
Boot to host shell [debug]
Select Install Junos Snapshot install the snapshot.
The software prompts you with the following option if you have Junos OS software
from the factory installed on the emergency boot device.
Juniper Linux Installer - (c) Juniper Networks 2014
Reboot
Install Juniper Linux Platform
Boot to host shell [debug]
Select Install Juniper Linux Platform to install the Junos OS software from the
emergency boot device.
4. The device copies the software from the emergency boot device, occasionally
displaying status messages. Copying the software can take up to 12 minutes.
When the software is finished being copied from the emergency device to the device,
the device reboots from the internal flash storage on which the software was just
installed. When the reboot is complete,the device displaysthe Junos OS login prompt:
root@switch#
5. Create a new configuration as you did when the device was shipped from the factory,
or restore the previously saved configuration file to the device.
6. Remove the emergency boot device.
Related
Documentation
• Creating an Emergency Boot Device on page 235
Copyright © 2016, Juniper Networks, Inc.238
QFX5100 Switch Hardware Guide
To Next Page
Loading...
