Keithley 2110 User Manual

Section
5: Remote commands Model 2110 5½ Digit Multimeter
Reference Manual
5-68 2110-901-01 Rev. C/August 2013
TRIGger:COUNt <n>|MIN|MAX|INFinite
Use this command to specify the number of triggers the instrument will accept before returning to the “idle” state.
Select from 1 to 50,000 triggers. Trigger count is ignored while in local operation.
Parameters
<n> description
1 to 50,000
Select value for the number of triggers.
MINimum
Select the minimum value.
MAXimum
Select the maximum value.
INFinite
Select INFinite to instruct the instrument to take triggers continuously.
Query
command description
TRIGger:COUNt?
Query the number of triggers. Returns “9.90000000E+37” when you
select the infinite trigger count.
TRIGger:COUNt? MIN
Query the minimum number of triggers.
TRIGger:COUNt? MAX
Query the maximum number of triggers.
TRIGger:DELay <n>|MIN|MAX
Use this command to select a trigger delay time in seconds. The delay is the time between the trigger signal and
each sample that follows. Specify a delay time from 0 to 3600 seconds.
Parameters
<n> description
0 to 3600
Specify a delay time from 0 to 3600 seconds.
Query
command description
TRIGger:DELay?
Query the trigger delay time.
TRIGger:DELay? MAX
Query the minimum trigger delay time.
TRIGger:DELay? MIN
Query the maximum trigger delay time.
Details
Refer to Trigger delay (on page 3-34) for information about sources.

Keithley 2110 Specifications

General

Model	2110
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
Continuity	Yes
Diode Test	Yes
Category	Digital Multimeter
Display	5.5 digit
DC Current Range	100 µA to 3 A
AC Current Range	100 µA to 3 A
Resistance Range	100 MΩ
Frequency Range	3 Hz to 300 kHz
Frequency Accuracy	0.01% + 1 count
Capacitance Range	1 nF to 100 µF
Capacitance Accuracy	1% + 5 counts
Connectivity	USB, GPIB (optional)
Dimensions	88 mm
Power Supply	100 V to 240 V AC, 50/60 Hz
DC Voltage Accuracy	±0.012% + 2 counts