Keithley 2110 User Manual

Model 2110
5½ Digit Multimeter Reference Manual Section 3:
Basic DMM operation
2110-901-01 Rev. C/August 2013 3-25
Connections to measure capacitance
Figure 24: Connections for capacitance
Remote operation
Commands that use the <n> parameter can use the MINimum and MAXimum name parameters. MIN
selects the minimum value and MAX selects the maximum value.
Use the following commands to select the capacitance function, set a measure range, and perform a
measurement:
FUNCtion "CAPacitance" Select capacitance function
CAPacitance:RANGe <n> Set capacitance range
<n> = 0 to 10e-3 Specify expected capacitance reading
CAPacitance:RANGe:AUTO <b> Enable or disable autorange
<b> = 0 or OFF
= 1 or ON
READ? Perform measurement and acquire reading
Measurement configuration commands can also be used to perform measurements. Use the
following command to select the capacitance function, set the measure range, set display resolution,
perform a measurement, and acquire the reading.
MEASure:CAPacitance? <range>, <resolution>
<range>= 0 to 10e-3 Expected capacitance reading
Resolution is ignored for capacitance.

Keithley 2110 Specifications

General

Model	2110
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
Continuity	Yes
Diode Test	Yes
Category	Digital Multimeter
Display	5.5 digit
DC Current Range	100 µA to 3 A
AC Current Range	100 µA to 3 A
Resistance Range	100 MΩ
Frequency Range	3 Hz to 300 kHz
Frequency Accuracy	0.01% + 1 count
Capacitance Range	1 nF to 100 µF
Capacitance Accuracy	1% + 5 counts
Connectivity	USB, GPIB (optional)
Dimensions	88 mm
Power Supply	100 V to 240 V AC, 50/60 Hz
DC Voltage Accuracy	±0.012% + 2 counts