Keithley 2280S-32-6 - Page 359

Series 2280 Precision DC Power Supply Reference Manual Section 8: Troubleshooting guide
077085503 / March 2019 8-7
Error code
Error message
-111
Header separator error
-110
Command header error
-109
Missing parameter
-108
Parameter not allowed
-106
Invalid program data separator
-105
GET not allowed
-104
Data type error
-103
Invalid separator
-102
Syntax error
-101
Invalid character
-100
Command error
0
No error
Calibration errors
100
Calibration error
101
Not permitted with cal locked
102
Calibration password is incorrect
105
Bad sequence of calibration commands
106
Calibration save failed
107
Calibration data lost
108
Busy on current step, wait until this step is completed
109
Not permitted with cal unlocked
110
Step1 Kmath error
111
Step1 V-DAC zero DMM reading out of range
112
Step1 V-ADC zero collected data error
113
Step2 V-DAC full scale DMM reading out of range
114
Step2 V-ADC full scale collected data error
115
Step3 I-ADC 100mA zero DMM reading out of range
116
Step3 100mA shunt value out of range
117
Step3 I-ADC 100mA zero collected data error
118
Step3 I-ADC 10mA zero collected data error
119
Step4 I-ADC 100mA full scale DMM reading out of range
120
Step4 100mA shunt value out of range
121
Step4 I-ADC 100mA full scale collected data error
122
Step5 I-ADC 10A zero DMM reading out of range
123
Step5 10A shunt value out of range