Section 8: Troubleshooting guide Series 2280 Precision DC Power Supply Reference Manual
8-8 077085503 / March 2019
Step5 I-ADC 10A zero collected data error
Step5 I-ADC 1A zero collected data error
Step6 I-DAC zero collected data error
Step7 I-ADC 10A full scale DMM reading out of range
Step7 10A shunt value out of range
Step7 I-ADC 10A full scale collected data error
Step8 I-DAC full scale collected data error
OXP or reverse sense error occurred during calibration
Incorrect CC/CV mode for one certain step
Not permitted when performing cal from front panel
List lengths not equivalent
Assigning data to undefined list
Attempt to run an empty list
Load list from USB flash drive failed
Load list from internal memory failed
Change Sense Function to V+I (CONCurrent) before running a list
Not permitted with list enabled
Open sense error occurred
Not permitted with output off
Not permitted before OXP or reverse sense error is cleared
Could not modify IP address
Could not modify subnet mask
Could not modify gateway address
To Next Page
Loading...
Need help?
General
