Keithley 2280S-32-6 - Page 361

Series 2280 Precision DC Power Supply Reference Manual Section 8: Troubleshooting guide
077085503 / March 2019 8-9
Error code
Error message
403
IP address, subnet mask and gateway address don’t match
406
IP conflicts
Other errors
500
Acquire data failed
501
Assign line failed
502
SDEViation not supported when trace buffer feed control is NEXT or ALWays
503
Only supports single channel
504
No upgrade found
507
Lines 4 to 6 don’t support function AUTO for single channel instrument
508
Querying manual input data of the line which is not set as Manual Input line
509
System password not correct
510
Parameter error
511
Communication not permitted
520
No USB flash drive found
521
Cannot open file
522
Load file from USB flash drive failed
523
Save file to USB flash drive failed
530
Attempt to call an empty global setup
540
Password is too long
541
Invalid character in password
600
Lines 1/3 don't support function DIGIN/DIGOUT for single channel instrument
601
Lines 2/4 to 6 don't support function AUTO for single channel instrument
602
Parameter error
603
Not supported in this mode
605
Line 1 will be fixed to ATUO when arm source is External
700
Not permitted in this work mode
701
Model length not enough
702
Full Voc can't be less than empty Voc
703
Not permitted with battery model is running
704
Too many model values
705
Model length not enough
708
Illegal model range setting