Keithley 2510 User Manual

Models 2510 and 2510-AT User’s Manual Status Structure 7-21
Programming example — read error queue
The following command reads the error queue:
STAT:QUE?
Table 7-9
Error queue commands
Command Description Default
STATus STATus Subsystem:
:QUEue Read Error Queue: (Note 1)
[:NEXT]? Read and clear oldest error/status (code and message).
:ENABle <list> Specify error and status messages for Error Queue. (Note 2)
:ENABle? Read the enabled messages.
:DISable <list> Specify messages not to be placed in queue. (Note 2)
:DISable? Read the disabled messages.
:CLEar Clear messages from Error Queue.
SYSTem SYSTem Subsystem:
:ERRor Read Error Queue: (Note 1)
[:NEXT]? Read and clear oldest error/status (code and message).
:ALL? Read and clear all errors/status (code and message).
:COUNt? Read the number of messages in queue.
:CODE Code numbers only:
[:NEXT]? Read and clear oldest error/status (code only).
:ALL? Read and clear all errors/status (codes only).
:CLEar Clear messages from Error Queue.
Notes:
1. Power-up and *CLS empties the Error Queue. STATus:PRESet has no effect.
2. Power-up enables error messages and disables status messages. *CLS and STATus:PRESet have no effect.

Keithley 2510 Specifications

General

Brand	Keithley
Model	2510
Category	Measuring Instruments
Language	English