Keithley 2510 User Manual

10-48 SCPI Command Reference Models 2510 and 2510-AT User’s Manual
ENABle <list>
:STATus:QUEue:ENABle <list> Enable messages for Error Queue
Parameters <list> = (numlist)
where numlist is a specified list of messages that you wish to enable for
the Error (must be in parentheses).
Query :ENABle? Query list of enabled messages
Description On power-up, all error messages are enabled and will go into the Error
Queue as they occur. Status messages are not enabled and will not go
into the queue. This command is used to specify which messages you
want enabled. Messages not specified will be disabled and prevented
from entering the queue.
DISable <list>
:STATus:QUEue:DISable <list> Disable messages for Error Queue
Parameters <list> = (numlist)
where numlist is a specified list of messages that you wish to disable for
the Error Queue in parentheses.
Query :DISable? Query list of disabled messages
Description On power-up, all error messages are enabled and will go into the Error
Queue as they occur. Status messages are not enabled and will not go
into the queue. This command is used to specify which messages you
want disabled. Disabled messages are prevented from going into the
Error Queue.
SYSTem subsystem
The SYSTem subsystem contains miscellaneous commands that are summarized in
Table 10-8.
Default conditions
:PRESet
:SYSTem:PRESet Return to :SYSTem:PRESet defaults
Description This command returns the instrument to states optimized for front panel
operation. :SYSTem:PRESet defaults are listed in Table 10-1 through
Table 10-10, and are the same as front panel BENCH defaults (See
Section 1).

Keithley 2510 Specifications

General

Brand	Keithley
Model	2510
Category	Measuring Instruments
Language	English