Models 2510 and 2510-AT User’s Manual SCPI Command Reference 10-47
Read condition registers
:CONDition?
:STATus:MEASurement:CONDition? Read Measurement Condition
:STATus:QUEStionable:CONDition? Read Questionable Register
:STATus:OPERation:CONDition? Read Operation Condition
Description These query commands are used to read the contents of the condition
registers.
Select default conditions
:PRESet
:STATus:PRESet Return registers to default conditions
Description When this command is sent, the following SCPI event registers are
cleared to zero (0):
1. Operation Event Enable Register.
2. Event Enable Register.
3. Measurement Event Enable Register.
NOTE The Standard Event Register is not affected by this command.
Error queue
[:NEXT]?
:STATus:QUEue[:NEXT]? Read Error Queue
Description As error and status messages occur, they are placed into the Error
Queue. This query command is used to read those messages. See
Appendix B for a list of messages.
NOTE The :STATus:QUEue[:NEXT]? query command performs the same function as
the :SYSTem:ERRor? query command. See “SYSTem subsystem,” page 10-48.
:CLEar
:STATus:QUEue:CLEar Clear Error Queue
Description This action command is used to clear the Error Queue of messages.
To Next Page
Loading...
