Models 2510 and 2510-AT User’s Manual Getting Started 1-21
Rules to navigate menus
Many functions and operations are configured from the front panel menus. Use the follow-
ing rules to navigate through these configuration menus:
• A menu item is selected by placing the cursor on it and pressing ENTER. Cursor
position is denoted by the blinking menu item or option. The EDIT left and right
arrow keys control cursor position.
• A displayed arrow on the bottom line indicates there are one or more additional
items (or messages) to select from. Use the appropriate EDIT cursor key to display
them.
• A numeric value is changed by placing the cursor on the digit to be changed and
using the EDIT
and
keys.
• A change is executed only when ENTER is pressed. Entering an invalid parameter
generates an error, and the entry is ignored. However, entering an out-of-range
value (too small or too large) selects the lower or upper limit, respectively.
• The EXIT key is used to back out of the menu structure. Any change that is not
entered is cancelled when EXIT is pressed.
Configuration menus
There are five configuration menus that can be accessed by pressing the CONFIG key fol-
lowed by the appropriate key (T, V, I, R, OUTPUT, or EDIT). Configuration menus on the
following pages are available for these operating functions:
• Temperature (CONFIG T): Table 1-5.
• Voltage source (CONFIG V): Table 1-6.
• Current source (CONFIG I): Table 1-7.
• Resistance (CONFIG R): Table 1-8.
• Output (CONFIG OUTPUT): Table 1-9.
• Setpoint tolerance (CONFIG EDIT): Table 1-10.
NOTE See “Configuring functions,” page 3-3, for parameter information.
To Next Page
Loading...
Need help?
General
