Keithley 2510 User Manual

10-12 SCPI Command Reference Models 2510 and 2510-AT User’s Manual
Table 10-7
:STATus subsystem commands
Command Description
Default
parameter SCPI
:STATus Note 1 ✓
:MEASurement Path to control measurement event registers.
[:EVENt]? Read the event register.
6
Note 2 ✓
:ENABle <NRf> | <NDN> Program the enable register. Note 3 ✓
:ENABle? Read the enable register.
6
✓
:CONDition? Read the condition register.
6
✓
:OPERation Path to control operation event registers. ✓
[:EVENt]? Read the event register.
6
Note 2 ✓
:ENABle <NRf> | <NDN> Program the enable register. Note 3 ✓
:ENABle? Read the enable register.
6
✓
:CONDition? Read the condition register.
6
✓
:QUEStionable Path to control questionable event registers. ✓
[:EVENt]? Read the event register.
6
Note 2 ✓
:ENABle <NRf> | <NDN> Program the enable register. Note 3 ✓
:ENABle? Read the enable register.
6
✓
:CONDition? Read the condition register.
6
✓
:PRESet Return status registers to default states. ✓
:QUEue Path to access error queue.
[:NEXT]? Read the most recent error message. Note 4 ✓
:ENABle <list> Specify error and status messages for queue. Note 5 ✓
:ENABle? Read the enabled messages. ✓
:DISable <list> Specify messages not to be placed in queue. Note 5
:DISable? Read the disabled messages.
:CLEar Clears all messages from Error Queue.
Notes:
1. Commands in this subsystem are not affected by *RST and :SYSTem:PREset. The effects of cycling power, *CLS and
:STATus:PRESet, are explained by the following notes.
2. Event Registers — Power-up and *CLS clears all bits.:STATus:PRESet has no effect.
3. Enable Registers — Power-up and :STATus:PRESet clears all bits. *CLS has no effect. Accepts the SCPI 1995.0 mandated (non-
decimal numeric) format (#H, #Q, or #B).
4. Error Queue — Power-up and *CLS clears all bits of the registers.
5. Error Queue Messages — Power-up clears list of messages. *CLS and :STATus:PRESet have no effect.
6. Register Query Commands — The format for the response messages (ASCII, hexadecimal, octal, or binary) depends on which
data format is presently selected. See the :FORMat:SREGister command.

Keithley 2510 Specifications

General

Brand	Keithley
Model	2510
Category	Measuring Instruments
Language	English