Models 2510 and 2510-AT User’s Manual Getting Started 1-3
Inspection
The Model 2510 was carefully inspected electrically and mechanically before shipment.
After unpacking all items from the shipping carton, check for any obvious signs of physi-
cal damage that may have occurred during transit. (There may be a protective film over the
display lens, which can be removed.) Report any damage to the shipping agent immedi-
ately. Save the original packing carton for possible future shipment. The following items
are included with every Model 2510 order:
• Model 2510 with line cord
• Mating input/output connector (Keithley part no. CS-846)
• Accessories as ordered
• Certificate of calibration
• User’s Manual
If an additional manual is required, order the appropriate manual package (for example,
2510-900-00). The manual packages include a manual and any pertinent addenda.
Options and accessories
The following options and accessories are available from Keithley for use with the
Model 2510.
INPUT/OUTPUT mating connector
One mating connector for the rear panel INPUT/OUTPUT connector is supplied. Addi-
tional part number CS-846 connectors can be ordered from Keithley.
Cables and adapters
Models 7007-1 and 7007-2 shielded GPIB cables
— Connect the Model 2510 to the
GPIB bus using shielded cables and connectors to reduce electromagnetic interference
(EMI). The Model 7007-1 is 1m long; the Model 7007-2 is 2m long.
Model 7009-5 shielded RS-232 cable
— Connects the Model 2510 to a computer serial
port using shielded cable and connectors to reduce EMI.
To Next Page
Loading...
Need help?
General
