Keithley 2510 User Manual

10-38 SCPI Command Reference Models 2510 and 2510-AT User’s Manual
DEFault 50Ω (100Ω RTD or thermistor)
5e2Ω (1kΩ RTD or thermistor)
5e3Ω (10kΩ thermistor)
5e4Ω (100kΩ thermistor)
:STATe <b> = ON | OFF Enable/disable protection
ON | 1 Enable protection
OFF | 0 Disable protection
Query [:HIGH][:LEVel]? Query high limit
[:HIGH]:TRIPped? Query if high limit exceeded (1 = exceeded)
:LOW[:LEVel]? Query low limit
:LOW:TRIPped? Query if low limit exceeded (1 = exceeded)
:STATe? Query if protection is enabled.
Description The :HIGH and :LOW commands program the high and low limits
respectively for the resistance function, while the :STATe command
enables and disables resistance function limits. The two :TRIPPed? que-
ries return a value of 1 if the corresponding limit is exceeded or a value
of 0 if it is not exceeded. :STATe? returns a value of 1 if protection is
enabled. Note that the high limit cannot be lower than the low limit, and
the low limit cannot be higher than the high limit.
Temperature function
[:SPOint] <n>
:SOURce[1]:TEMPerature:[SPOint] <n> Program temperature setpoint
Parameters <n> = -50 to +225°C Set temperature setpoint
223.15 to 498.15K
-58 to 437°F
MINimum -50°C
223.15K
-58°F
MAXimum +225°C
498.15K
437°F
DEFault +25°C
298.15K
77°F
Query [:SPOint]? Query temperature setpoint
Description This command programs the temperature setpoint for the temperature
function. This value is the temperature at which the Model 2510 will
maintain system temperature when the temperature function is enabled.
The setpoint cannot exceed the temperature protection limits.

Keithley 2510 Specifications

General

Brand	Keithley
Model	2510
Category	Measuring Instruments
Language	English