Keithley 2510 User Manual

10-44 SCPI Command Reference Models 2510 and 2510-AT User’s Manual
Select minimum overshoot criteria
:MOVershoot
:SOURce[1]:TEMPerature:ATUNe:LCONstants:MOVershoot:GAIN? Query gain constant
:SOURce[1]:TEMPerature:ATUNe:LCONstants:MOVershoot:DERivative? Query derivative constant
:SOURce[1]:TEMPerature:ATUNe:LCONstants:MOVershoot:INTegral? Query integral constant
:SOURce[1]:TEMPerature:ATUNe:LCONstants:MOVershoot:TRANsfer Set constants as defaults
Description These commands are used to control PID autotuning for minimum over-
shoot criteria. (See Section 4.) The GAIN, DER, and INT queries
request the autotune loop constant values while the TRAN command
transfers constants as default values.
Query tau and lag values
:SOURce[1]:TEMPerature:ATUNe:TAU? Query tau value
:SOURce[1]:TEMPerature:ATUNe:LAG? Query lag constant
Description These queries are used to query the autotune tau and lag values.
Set temperature start and stop values
:SOURce[1]:TEMPerature:ATUNe:STARt <n> Set start temperature
:SOURce[1]:TEMPerature:ATUNe:STOP <n> Set stop temperature
Description These commands are used to control the start and stop temperatures for
PID autotuning (See Section 4.)
Parameters <n> = -50 to +225˚C
223.15 to 498.15K
-58 to 437˚F
Query :STARt? Query start temperature
:STOP? Query stop temperature
Description These commands are used to set the start and stop temperatures for the
autotune procedure. The Model 2510-AT will use these values to deter-
mine the correct loop constants.
Initiate autotune
:SOURce[1]:TEMPerature:ATUNe:INITiate Initiate autotune
Description This command is used to initiate the autotune process. You must first set
the start and stop temperatures before starting the process as described
in Section 4.

Keithley 2510 Specifications

General

Brand	Keithley
Model	2510
Category	Measuring Instruments
Language	English