1-20 Getting Started Models 2510 and 2510-AT User’s Manual
Menu item
1
Description Parameters
CAL
3
UNLOCK
EXECUTE
VIEW DATES
SAVE
LOCK
CHANGE-PASSWORD
TEST
DISPLAY TESTS
4
KEYS
DISPLAY-PATTERNS
CHAR SET
A/D CTRL
LINE-FREQUENCY
GENERAL
DIGOUT
SERIAL#
TIMESTAMP
NUMBERS
Calibrate Model 2510. (See Service Manual.)
Unlock calibration.
Execute calibration steps.
Display calibration dates and count.
Save calibration constants.
Lock out calibration.
Change calibration password.
Perform tests on Model 2510.
Test front panel keys and display digits.
Test front panel keys.
Test display pixels and annunciators.
Test display characters.
Select line frequency.
Set the line frequency.
Select general operations.
Set Digital I/O port bit pattern.
Display serial number, firmware revision, SCPI version.
Reset timestamp.
Select engineering units or scientific notation display
format (top display line only). Select FLOATING
EXP or FIXED EXP for SCIENTIFIC.
50 or 60Hz
0 to 15
YES or NO
ENGR,
SCIENTIFIC
NOTES
1
Top level menu choices indicated in bold. Indentation identifies each lower submenu level.
2
When the remote operation interface selection (GPIB or RS-232) is changed, the Model 2510 performs a power-on reset. To check or
change options of the selected interface, you must re-enter the menu structure.
3
Only VIEW DATES is accessible when calibration is locked. Password required to unlock calibration. See Service Manual.
4
Press EXIT key to cancel test.
Table 1-4 (continued)
Main menu
To Next Page
Loading...
Need help?
General
