Keithley 2510 - Page 15

D IEEE-488 and SCPI Conformance Information
Introduction ............................................................................... D-2
E Example Programs
Introduction ................................................................................ E-2
Program requirements ................................................................ E-2
Computer hardware requirements ....................................... E-2
Software requirements ........................................................ E-2
General program instructions .............................................. E-2
Basic temperature control program ............................................ E-3
Instrument setup .................................................................. E-3
Requested readings ............................................................. E-3
Setpoint tolerance temperature sweep ........................................ E-4
Overview ............................................................................. E-4
Enabling SRQ on setpoint tolerance ................................... E-5
Temperature sweep program summary ............................... E-5
Program 1: Basic temperature control ....................................... E-6
Program 2: Setpoint tolerance temperature sweep .................... E-8
F GPIB 488.1 Protocol
Introduction ................................................................................ F-2
Selecting the 488.1 protocol ....................................................... F-2
Protocol differences ................................................................... F-3
Message exchange protocol (MEP) .................................... F-3
Using SCPI-based programs ............................................... F-3
Bus hold-off ........................................................................ F-4
Trigger-on-talk .................................................................... F-4
Message available ............................................................... F-4
General operation notes ...................................................... F-4