Keithley 2510 User Manual

Digital output 5-3
Output 3-8
Output enable 5-6
Setpoint tolerance 3-8
Source meter output 3-8
Temperature 3-3
Temperature measurement 3-3
Voltage 3-5
Voltage measurement 3-3
Conformance information
IEEE-488 and SCPI D-1
Connections
2-wire 2-2
2-wire input/output 2-2, 2-5
4-wire 2-3
4-wire input/output 2-3, 2-5
GPIB 6-4
Input/output 2-2
RS-232 6-8
TEC heating and cooling 2-4
Connector
Digital I/O 1-7
GPIB 1-7
INPUT/OUTPUT 1-3
Input/output 1-7, 2-2
Line power 1-7
RS-232 1-7
Trigger link 1-7
Contact information 1-2
Control display 10-14
Controlling digital output lines 5-4
Current
Configuration 3-5
Menus 1-24
Protection limits 3-14
Readings 1-11
D
Data bits and parity 6-7
DC resistance 9-3
Configuration 3-6
DCL (device clear) 6-12
Define
TEXT messages 10-15
Digital I/O port 1-7, 5-2
Display 1-10
Examples 1-13
Format 1-10
Messages 1-14
Readings 1-11
DISPlay subsystem 10-14
DISPLAY TOGGLE/LOCAL key 6-10
E
Error and status messages 6-9, B-2
Example
2-wire I/O connections 2-2
4-wire I/O connections 2-3
Autotuning 4-12
Basic temperature control E-6
Digital I/O, sink operation 5-3
Digital I/O, source operation 5-4
Engineering units display 1-12
Firmware revision display 1-8
Front panel control-measure
procedure 3-10
PID control graph 4-5
PID response comparison, long lag and
Tau times 4-8
PID response comparison, short lag and
Tau times 4-7
Proportional control graph 4-3
Remote command, case sensitive 6-14
Remote command, leading colon 6-15
Remote command, query 6-14
Remote command, short form 6-15
Remote control-measure procedure 3-11
Remote response messages 6-18
RTD sensor DC resistance configuration
program 3-6
RTD sensor temperature configuration
program 3-3
Scientific notation display 1-12
Sensing method, 2-wire 2-6
Sensing method, 4 wire 2-6
Setpoint tolerance graph 3-17
TEC heating and cooling connections 2-4
Example programs E-1
Program requirements E-2
Setpoint tolerance temperature
sweep E-4, E-8
Temperature control E-3, E-6
Examples
Front panel displays 1-13
List parameter 7-20
Message exchange protocol (MEP) F-3
Multiple command message 6-16
Output enable configurations 5-7
Program and read register
programming 7-19
Remote :FETCH? query 3-12
Remote command rules 6-17

Keithley 2510 Specifications

General

Brand	Keithley
Model	2510
Category	Measuring Instruments
Language	English