Menus ....................................................................................... 1-19
Main menu ......................................................................... 1-19
Rules to navigate menus .................................................... 1-21
Configuration menus ......................................................... 1-21
2 Connections
Input/output connections ............................................................ 2-2
Input/output connector ........................................................ 2-2
2-wire connections .............................................................. 2-2
4-wire connections ....................................................... 2-3
Reversing TEC connections ................................................ 2-4
Sense selection ............................................................................ 2-5
OUTPUT sensing ................................................................ 2-5
INPUT sensing .................................................................... 2-5
Sensing considerations ........................................................ 2-5
2-wire sensing .............................................................. 2-5
4-wire sensing .............................................................. 2-6
Ground connect mode ................................................................. 2-7
AC ohms measurement ............................................................... 2-7
3 Basic Operation
Safety precautions ...................................................................... 3-2
Operation overview .................................................................... 3-2
Control characteristics ......................................................... 3-2
Measurement characteristics ............................................... 3-2
Limit characteristics ............................................................ 3-3
Configuring functions ................................................................. 3-3
Configuring temperature ..................................................... 3-3
Configuring voltage ............................................................. 3-5
Configuring current ............................................................. 3-5
Configuring DC resistance .................................................. 3-6
Configuring AC resistance ................................................... 3-6
Configuring output .............................................................. 3-8
Configuring setpoint tolerance ............................................ 3-8
Adjusting setpoints ..................................................................... 3-9
Basic front panel control-measure procedure ........................... 3-10
Step 1: Select function. .............................................. 3-10
Step 2: Configure function. ........................................ 3-10
Step 3: Adjust setpoint. .............................................. 3-10
Step 4: Set current limit. ............................................ 3-10
Step 5: Turn output on. ............................................... 3-11
Step 6: Observe the display. ....................................... 3-11
Step 7: Turn output off. .............................................. 3-11
To Next Page
Loading...
Need help?
General
