Keithley 2657A

Section 5: Introduction to TSP operation Model 2657A High Power System SourceMeter® Instrument Reference Manual
5-10 2657A-901-01 Rev. B/December 2012
Reading buffer
Reading buffers capture measurements, ranges, instrument status, and output states of the
instrument.
bufferVar.appendmode (on page 7-16)
bufferVar.basetimestamp
(on page 7-16)
bufferVar.cachemode
(on page 7-17)
bufferVar.capacity
(on page 7-18)
bufferVar.clear()
(on page 7-19)
bufferVar.clearcache()
(on page 7-19)
bufferVar.collectsourcevalues
(on page 7-20)
bufferVar.collecttimestamps
(on page 7-21)
bufferVar.fillcount
(on page 7-22)
bufferVar.fillmode
(on page 7-22)
bufferVar.measurefunctions
(on page 7-23)
bufferVar.measureranges
(on page 7-24)
bufferVar.n
(on page 7-25)
bufferVar.readings
(on page 7-26)
bufferVar.sourcefunctions
(on page 7-27)
bufferVar.sourceoutputstates
(on page 7-28)
bufferVar.sourceranges
(on page 7-28)
bufferVar.sourcevalues
(on page 7-29)
bufferVar.statuses
(on page 7-30)
bufferVar.timestampresolution
(on page 7-31)
bufferVar.timestamps
(on page 7-32)
savebuffer()
(on page 7-156)
smuX.buffer.getstats()
(on page 7-177)
smuX.buffer.recalculatestats()
(on page 7-178)
smuX.makebuffer()
(on page 7-193)
smuX.nvbufferY
(on page 7-210)
smuX.savebuffer()
(on page 7-211)
Reset
Resets settings to their default settings.
digio.trigger[N].reset() (on page 7-55)
lan.reset()
(on page 7-118)
localnode.reset()
(on page 7-139)
reset()
(on page 7-155)
timer.reset()
(on page 7-330)
trigger.blender[N].reset()
(on page 7-333)
trigger.timer[N].reset()
(on page 7-341)
tsplink.trigger[N].reset()
(on page 7-354)
RS-232
serial.baud (on page 7-168)
serial.databits
(on page 7-169)
serial.flowcontrol
(on page 7-169)
serial.parity
(on page 7-170)
serial.read()
(on page 7-171)
serial.write()
(on page 7-171)