Keithley 2657A User Manual

Section 7: TSP command reference Model 2657A High Power System SourceMeter® Instrument Reference Manual
7-112 2657A-901-01 Rev. B/December 2012
Example
print(lan.config.dns.hostname)
Outputs the present dynamic DNS host name.
Also see
lan.config.dns.dynamic (on page 7-110)
lan.restoredefaults()
(on page 7-118)
lan.config.dns.verify
This attribute defines the DNS host name verification state.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes LAN restore defaults Nonvolatile memory 1 (lan.ENABLE)
Usage
state = lan.config.dns.verify
lan.config.dns.verify = state
state
DNS hostname verification state:
1 or lan.ENABLE: DNS host name verification enabled
0 or lan.DISABLE: DNS host name verification disabled
Details
When this is enabled, the instrument performs DNS lookups to verify that the DNS host name matches the value
specified by lan.config.dns.hostname.
Example
print(lan.config.dns.verify)
Outputs the present DNS host name verification
state.
If it is enabled, the output is:
1.00000e+00
Also see
lan.config.dns.hostname (on page 7-111)
lan.restoredefaults()
(on page 7-118)
lan.config.duplex
This attribute defines the LAN duplex mode.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes LAN restore defaults Nonvolatile memory 1 (lan.FULL)
Usage
duplex = lan.config.duplex
lan.config.duplex = duplex
duplex
LAN duplex setting can be one of the following values:
1 or lan.FULL: Selects full-duplex operation
0 or lan.HALF: Selects half-duplex operation

Keithley 2657A Specifications

General

Brand	Keithley
Model	2657A
Category	Measuring Instruments
Language	English