Keithley 2657A User Manual

Model 2657A High Power System SourceMeter® Instrument Reference Manual Section 7: TSP command reference
2657A-901-01 Rev. B/December 2012 7-335
trigger.blender[N].wait()
This function waits for a blender trigger event to occur.
Type TSP-Link accessible
Affected by Where saved Default value
Function Yes
Usage
triggered = trigger.blender[N].wait(timeout)
triggered
Trigger detection indication for blender
N
The trigger blender (1 to 4) on which to wait
timeout
Maximum amount of time in seconds to wait for the trigger blender event
Details
This function waits for an event blender trigger event. If one or more trigger events were detected since the last
time trigger.blender[N].wait() or trigger.blender[N].clear() was called, this function returns
immediately.
After detecting a trigger with this function, the event detector automatically resets and rearms. This is true
regardless of the number of events detected.
Example
digio.trigger[3].mode = digio.TRIG_FALLING
digio.trigger[5].mode = digio.TRIG_FALLING
trigger.blender[1].orenable = true
trigger.blender[1].stimulus[1] = digio.trigger[3].EVENT_ID
trigger.blender[1].stimulus[2] = digio.trigger[5].EVENT_ID
print(trigger.blender[1].wait(3))
Generate a trigger blender 1
event when a digital I/O
trigger happens either on
line 3 or 5.
Wait three seconds while
checking if trigger blender 1
event has occurred.
If the blender trigger event
has happened, then true is
output. If the trigger event
has not happened, then
false is output after the
timeout expires.
Also see
trigger.blender[N].clear() (on page 7-330)

Keithley 2657A Specifications

General

Brand	Keithley
Model	2657A
Category	Measuring Instruments
Language	English