Keithley 2657A

A
ppendix E: Status model Model 2657A High Power System SourceMeter® Instrument Reference Manual
E-4 2657A-901-01 Rev. B/December 2012
Status function summary
The following functions and attributes control and read the various registers. Additional information for
the various register sets is included later in this section. Also, refer to the specific command as listed
in TSP commands
(on page 7-8).
Status function summary
Type Function or attribute
Status summary
status.condition
status.node_enable
status.node_event
status.request_enable
status.request_event
status.reset
Measurement event
status.measurement.*
status.measurement.buffer_available.*
status.measurement.current_limit.*
status.measurement.instrument.*
status.measurement.instrument.smua.*
status.measurement.overvoltage.*
status.measurement.reading_overflow.*
status.measurement.sink_limit.*
status.measurement.voltage_limit.*
Operation status
status.operation.*
status.operation.calibrating.*
status.operation.instrument.*
status.operation.instrument.digio.*
status.operation.instrument.digio.trigger_overrun.*
status.operation.instrument.lan.*
status.operation.instrument.lan.trigger_overrun.*
status.operation.instrument.smua.*
status.operation.instrument.smua.trigger_overrun.*
status.operation.instrument.trigger_blender.*
status.operation.instrument.trigger_blender.trigger_overrun.*
status.operation.instrument.trigger_timer.*
status.operation.instrument.trigger_timer.trigger_overrun.*
status.operation.instrument.tsplink.*
status.operation.instrument.tsplink.trigger_overrun.*
status.operation.measuring.*
status.operation.remote.*
status.operation.sweeping.*
status.operation.trigger_overrun.*
status.operation.user.*
Questionable status
status.questionable.*
status.questionable.calibration.*
status.questionable.instrument.*
status.questionable.instrument.smua.*
status.questionable.over_temperature.*
status.questionable.unstable_output.*
Standard event
status.standard.*
System summary
status.system.*
status.system2.*
status.system3.*
status.system4.*
status.system5.*
* = .condition, .event, .ntr, .ptr and .enable;