Keithley 2657A

Section 7: TSP command reference Model 2657A High Power System SourceMeter® Instrument Reference Manual
7-354 2657A-901-01 Rev. B/December 2012
tsplink.trigger[N].reset()
This function resets some of the TSP-Link trigger attributes to their factory defaults.
Type TSP-Link accessible
Affected by Where saved Default value
Function Yes
Usage
tsplink.trigger[N].reset()
N
The trigger line (1 to 3)
Details
The tsplink.trigger[N].reset() function resets the following attributes to their factory defaults:
• tsplink.trigger[N].mode
• tsplink.trigger[N].stimulus
• tsplink.trigger[N].pulsewidth
This also clears tsplink.trigger[N].overrun.
Example
tsplink.trigger[3].reset()
Resets TSP-Link trigger line 3
attributes back to factory default
values.
Also see
tsplink.trigger[N].mode (on page 7-350)
tsplink.trigger[N].overrun
(on page 7-352)
tsplink.trigger[N].pulsewidth
(on page 7-353)
tsplink.trigger[N].stimulus
(on page 7-354)
tsplink.trigger[N].stimulus
This attribute specifies the event that causes the synchronization line to assert a trigger.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes Instrument reset
Recall setup
TSP-Link trigger N reset
Not saved 0