To Next Page

To Previous Page

ppendix C: LAN concepts and settings Model 2657A High Power System SourceMeter® Instrument Reference Manual

C-2 2657A-901-01 Rev. B/December 2012

Contact your corporate information technology (IT) department for permission before you connect the

Model 2657A to a corporate network.

If you have problems, see LAN troubleshooting suggestions (on page 8-8).

Record all network configurations before modifying any existing network configuration information on

the network interface card. Once the network configuration settings are updated, the previous

information is lost. This may cause a problem reconnecting the host computer to a corporate network,

particularly if DHCP Enabled = NO (disabled).

Be sure to return all settings to their original configuration before reconnecting the host computer to a

corporate network. Failure to do this could result in loss of data. Contact your system administrator for

more information.

Step 1: Identify and record the existing IP configuration

To identify the existing IP configuration:

1. Open a command prompt window:

Microsoft

Windows

2000 or Windows XP:

a. Click Start and select Run.

b. In the Open field, type cmd.

c. Click OK.

Microsoft Windows Vista

or Windows 7:

a. Click Start.

b. Select All Programs > Accessories > Command Prompt.

2. At the command prompt, type ipconfig/all and press the Enter key. A list of existing IP

configuration information for your computer is displayed.

CAUTION

NOTE

Keithley 2657A User Manual

Questions and Answers: