Keithley 2657A User Manual

Section 7: TSP command reference Model 2657A High Power System SourceMeter® Instrument Reference Manual
7-330 2657A-901-01 Rev. B/December 2012
Example 2
beeper.beep(0.5, 2400)
print("reset timer")
timer.reset()
delay(0.5)
dt = timer.measure.t()
print("timer after delay:", dt)
beeper.beep(0.5, 2400)
Sets the beeper, resets the timer, sets a delay, then
verifies the time of the delay before the next beeper.
Output:
reset timer
timer after delay: 5.00e-01
Also see
timer.reset() (on page 7-330)
timer.reset()
This function resets the timer to zero (0) seconds.
Type TSP-Link accessible
Affected by Where saved Default value
Function Yes
Usage
timer.reset()
Example
timer.reset()
-- (intervening code)
time = timer.measure.t()
print(time)
Resets the timer and then measures the time since
the reset.
Output:
1.469077e+01
The above output indicates that
timer.measure.t() was executed 14.69077
seconds after timer.reset().
Also see
timer.measure.t() (on page 7-329)
trigger.blender[N].clear()
This function clears the blender event detector and resets blender N.
Type TSP-Link accessible
Affected by Where saved Default value
Function Yes
Usage
trigger.blender[N].clear()
N
The blender number (1 to 4)
Details
This command sets the blender event detector to the undetected state and resets the event detector's overrun
indicator.

Keithley 2657A Specifications

General

Brand	Keithley
Model	2657A
Category	Measuring Instruments
Language	English