Model 2657A High Power System SourceMeter® Instrument Reference Manual Section 7: TSP command reference
2657A-901-01 Rev. B/December 2012 7-115
lan.config.speed
This attribute contains the LAN speed used when restarting in manual configuration mode.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes LAN restore defaults Nonvolatile memory 100 (100 Mbps)
Usage
speed = lan.config.speed
lan.config.speed = speed
speed
LAN speed setting in Mbps (10 or 100)
Details
This attribute stores the speed that will be used if the LAN is restarted for manual configuration operation.
This attribute does not indicate the actual setting presently in effect. Use the lan.status.speed attribute to
determine the present operating state of the LAN.
The LAN speed is measured in megabits per second (Mbps).
Example
lan.config.speed = 100
Configure LAN speed for 100.
Also see
lan.restoredefaults() (on page 7-118)
lan.status.speed
(on page 7-124)
lan.config.subnetmask
This attribute contains the LAN subnet mask.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes LAN restore defaults Nonvolatile memory "255.255.255.0"
Usage
mask = lan.config.subnetmask
lan.config.subnetmask = mask
mask
String that specifies the LAN subnet mask value in dotted decimal notation
Details
This attribute specifies the LAN subnet mask that will be used when the manual configuration method is used to
configure the LAN. This setting is ignored when DLLA or DHCP is used.
This attribute does not indicate the actual setting presently in effect. Use the lan.status.subnetmask
attribute to determine the present operating state of the LAN.
Example
print(lan.config.subnetmask)
Outputs the LAN subnet mask, such as:
255.255.255.0
To Next Page
Loading...
Need help?
General
