Section 8: Troubleshooting guide Model 2657A High Power System SourceMeter® Instrument Reference Manual
8-6 2657A-901-01 Rev. B/December 2012
Error summary
Error number Error level Error Message
2410 RECOVERABLE TSPnet max connections reached
2411 RECOVERABLE TSPnet connection failed
2412 RECOVERABLE TSPnet invalid termination
2413 RECOVERABLE TSPnet invalid reading buffer table
2414 RECOVERABLE TSPnet invalid reading buffer index range
2415 RECOVERABLE TSPnet feature only supported on TSP connections
2416 RECOVERABLE TSPnet must specify both port and init
2417 RECOVERABLE TSPnet disconnected by other side
2418 RECOVERABLE TSPnet read input buffer overflow
2419 RECOVERABLE Invalid format specifier
2500 RECOVERABLE Average delay must be at least NNN seconds
4900 RECOVERABLE Reading buffer index NN is invalid
4903 RECOVERABLE Reading buffer expired
5001 FATAL SMU is unresponsive. Disconnect DUT and cycle power
5003 SERIOUS Saved calibration constants corrupted
5004 RECOVERABLE Operation conflicts with CALA sense mode
5005 RECOVERABLE Value too big for range
5007 RECOVERABLE Operation would exceed safe operating area of the instrument
5008 RECOVERABLE Operation not permitted while OUTPUT is on
5009 SERIOUS Unknown sourcing function
5010 SERIOUS No such SMU function
5011 RECOVERABLE Operation not permitted while cal is locked
5012 RECOVERABLE Cal data not saved - save or restore before lock
5013 RECOVERABLE Cannot save cal data - unlock before save
5014 RECOVERABLE Cannot restore cal data - unlock before restore
5015 RECOVERABLE Save to cal set disallowed
5016 RECOVERABLE Cannot change cal date - unlock before operation
5017 RECOVERABLE Cannot change cal constants - unlock before operation
5018 SERIOUS Cal version inconsistency
5019 RECOVERABLE Cannot unlock - invalid password
5021 SERIOUS Cannot restore default calset. Using previous calset
5022 SERIOUS Cannot restore previous calset. Using factory calset
5023 SERIOUS Cannot restore factory calset. Using nominal calset
5024 SERIOUS Cannot restore nominal calset. Using firmware defaults
5025 RECOVERABLE Cannot set filter.count > 1 when measure.count > 1
5027 RECOVERABLE Unlock cal data with factory password
5028 RECOVERABLE Cannot perform requested operation while source autorange is
enabled
5029 RECOVERABLE Cannot save without changing cal adjustment date
5032 RECOVERABLE Cannot change this setting unless buffer is cleared
5033 RECOVERABLE Reading buffer not found within device
5038 RECOVERABLE Index exceeds maximum reading
5039 RECOVERABLE Measure count exceeds buffer capacity
5040 RECOVERABLE Cannot use same reading buffer for multiple overlapped
measurements
5042 RECOVERABLE Cannot perform requested action while an overlapped operation is in
progress
5043
RECOVERABLE Cannot perform requested operation while voltage measure
autorange is enabled
To Next Page
Loading...
Need help?
General
