Keyence IV2 Series - Advanced settings for the width tool

4-94
IV2 Series User's Manual (Control Panel)
3. Tool Settings (Setting the Judgment Method of the Target of Standard Mode)
Advanced settings for the width tool
Items Description Setting range Ref.
Edge Sensitivity Manual Adjustment
Manually adjust the sensitivity that
detects the edge that will become
the standard of reference for width
extraction.
1 to 100
(default: 50)
4-95To Live Image
The edge sensitivity can be adjusted
from the Live image of the target.
--
Edge Sensitivity
Auto Adjustment
Automatically adjust the sensitivity
that detects the edge that will become
the standard of reference for width
extraction.
--
Width Extraction Method
Select the method used to extract the
target width.

Mas. Wid. (default)
Detects the width which is similar
to the width registered in the
master image, and extracts its
width.

Outside
Extracts the outer-most width in
the tool window.

Inside
Extracts the inner-most width in
the tool window.
4-96
Scaling
Scaling
Set when length is being used for
anomaly detection instead of the
matching rate.

ON
Enable scaling.

OFF (default)
Disable scaling.
4-96
Display Value
When scaling is enabled, input the
display value in relation to matching
rate (*) 100.
0.05 to 9999
(Maximum input digits: 4)
(default: 100.0)
Copy Setting
When scaling is enabled, copy the
scaling settings from another tool.
--
Tool Name
Auser-speciedname,suchasthe
name of the target, can be set for the
tool. Tool names can be checked on
the run screen.
“5 Running” (Page 5-1)
Up to 16 characters can be set. 4-97
* A matching rate of 100 indicates that the target width is completely matched to the master image width. The matching
rate becomes smaller with a narrower width and larger with a wider width.
4
Settings Navigator