2
IV2 Series User's Manual (Control Panel)
Important Instructions
Important Instructions
Observe the following precautions to prevent malfunction of the IV2 series and to ensure that it is
used properly.
Precautions on use
The power of this product and instruments connected to this product must be turned o when the cable is
to be installed or removed. Failure to do so may cause an electric shock or product damage.
Use this product with the correct supply voltage. Failure to do so may cause product damage.
For instructions
Do not turn OFF the power while setting the items or saving the settings. Otherwise, all or part of the
setting data may be lost.
Do not let water, dust or oil stick to the camera/light of the sensor head. Failure to do so may cause a
malfunction.
The enclosure rating of the control panel (IV2-CP50) is IP40. This product is not designed to be waterproof,
so use care when operating around water.
When this product becomes dirty, do not rub it with a wet cloth, benzene, thinner, or alcohol. Doing so
may change the color or shape of the unit.
If the unit is heavily contaminated, disconnect all the cables including the power supply cable, wipe o
the dirt with a cloth soaked with mild detergent, and then wipe with a soft dry cloth.
For the LCD panel
Do not press the touch panel with the tip of your nail or anything that has a sharp tip such as a pen or a
screwdriver. Doing so may cause damage.
Do not apply shock to the touch panel or press it with excessive force. Doing so may cause damage.
The LCD panel may have some dots that are always lit (bright dots) or ones that are always unlit (black
dots). This phenomenon is not a problem.
Due to the unique characteristics of the LCD, displaying the same image for a long time may cause an
afterimage.
For USB memory
Use the KEYENCE recommended product.
A USB memory device with a security function cannot be used.
Unplug the USB memory when turning on or o the power of the IV2 Series.
Do not remove the USB memory while the USB is being written on. Otherwise, all or part of the setting
data may be lost or there may be damage to the memory.
For external master image registration
If the external master image registration is to be performed frequently, set [Write ROM when using “Ext.
Master Save”?] of the input option to [No] to protect the nonvolatile memory of the internal sensor. When
the option is set to [Yes], the nonvolatile memory is guaranteed to write for 100,000 times.
For automatic focus function
Automatic focus function is used for adjusting the focusing position at the time of installation. Disabled
during the operation.
Focusing position can be registered in each program. The program congurations are guaranteed to
switch for 100,000 times. If the focusing position does not need to change for each program, set [Auto
Focus Adj Pos] to [Common] to extend the life-span.
Do not apply shock or vibration to the sensor head during the focusing position adjustment. Failure to
do so may cause product damage.
About SD Card
Use the KEYENCE recommended product.
Close the cover of the SD card slot while in use.
When removing the SD card, be sure to perform [SD card removal] before removing.
Do not remove the SD card while accessing the SD card. Also, do not turn o the power while accessing
the SD card. Otherwise, all or part of the setting data may be lost or there may be damage to the memory.
To prevent data loss, periodically backing up to another storage device is recommended.
To Next Page
Loading...