Keysight Technologies N6900 Series - Page 294

SCPI Command *RST Settings
SENSe:THReshold<n>:VOLTage 0
SENSe:THReshold<n>:WHOur 0
SENSe:WINDow RECTangular
STEP:TOUTput OFF
TRIGger:ACQuire:CURRent 0
TRIGger:ACQuire:CURRent:SLOPe POSitive
TRIGger:ACQuire:SOURce BUS
TRIGger:ACQuire:TOUTput OFF
TRIGger:ACQuire:VOLTage 0
TRIGger:ACQuire:VOLTage:SLOPe POSitive
TRIGger:ARB:SOURce BUS
TRIGger:ELOG:SOURce BUS
TRIGger:TRANsient:SOURce BUS
VOLTage 0.1% of rating
VOLTage:LIMit 1% of rating
VOLTage:MODE FIXed
VOLTage:PROTection 120% of rating
VOLTage:SLEW MAX
VOLTage:SLEW:MAXimum ON
VOLTage:TRIGgered 0.1% of rating
The following table shows the as-shipped settings of the non-volatile parameters. These are not
affected by power cycling or *RST.
Non-Volatile Settings
SCPI as-shipped settings
CALibrate:DATE March 5, 2003
CALibrate:PASSword 0
DIGital:PIN<all>:FUNCtion DINput
DIGital:PIN<all>:POLarity POSitive
DISPlay:VIEW METER_VI
OUTPut:COUPle OFF
OUTPut:COUPle:DOFFset 0
OUTPut:INHibit:MODE OFF
OUTPut:PON:STATe RST
Keysight N6900/N7900 Series Operating and Service Guide 294
6 SCPI Programming Reference