Kodak DirectView CR 825 User Manual

DIAGNOSTICS Checkout Procedures
10DEC05
DG4825-1
Page
159 of 180
2 Use the following table to help you check the malfunction.
Description Possible Cause Action
The UNINTERRUPTED
POWER SUPPLY UPS1 is
not energized:
• LEDs are not
illuminated
• ALARM does not emit a
beep
The “ON/TEST” BUTTON is not
engaged.
Press the “ON/TEST”
BUTTON.
The REAR PANEL INPUT
CIRCUIT BREAKER is actuated.
Reset the CIRCUIT
BREAKER.
The BATTERY in the
UNINTERRUPTED POWER
SUPPLY UPS1 has a low charge.
Wait for the recovery of
the charge in the
BATTERY.
The UNINTERRUPTED POWER
SUPPLY UPS1 has a malfunction.
Install a new
UNINTERRUPTED
POWER SUPPLY UPS1.
The REPLACE BATTERY
LED is illuminated.
The BATTERY in the
UNINTERRUPTED POWER
SUPPLY UPS1 has no charge.
Install a new
UNINTERRUPTED
POWER SUPPLY UPS1.
• The FAULT LED is
illuminated.
• The ALARM emits a
beep.
The UNINTERRUPTED POWER
SUPPLY UPS1 has a malfunction.
Install a new
UNINTERRUPTED
POWER SUPPLY UPS1.

Kodak DirectView CR 825 Specifications

General

Brand	Kodak
Model	DirectView CR 825
Category	Medical Equipment
Language	English