Kodak DirectView CR 825 - 12915 - SLOW SCAN CONTROLLER BOARD A6: Unexpected Retry; 12913 - SLOW SCAN CONTROLLER BOARD A6: Unexpected Retry; 12911 - SLOW SCAN CONTROLLER BOARD A6: Unexpected Retry; 12908 - SLOW SCAN CONTROLLER BOARD A6: Unexpected Retry

DIAGNOSTICS Error Codes
10DEC05
DG4825-1
Page
83 of 180
12914 - SLOW SCAN CONTROLLER BOARD A6: Unexpected Retry
12915 - SLOW SCAN CONTROLLER BOARD A6: Unexpected Retry
12930 - SLOW SCAN: Unexpected Retry during Current Test
12931 - SLOW SCAN: Unexpected Retry during Velocity Test
Description: The command MOVE TO EXTRACTION BAR REFERENCE SENSOR
did not occur. The command is executed again.
Cause: The SLOW SCAN CONTROLLER BOARD A6 malfunctioned.
Action: Do the checkout for the SLOW SCAN CONTROLLER BOARD A6 and COIL
BOARD A7.
Description: The command MOVE TO THE PLATE GUIDE POSITION did not occur.
The command is executed again.
Cause: The SLOW SCAN CONTROLLER BOARD A6 malfunctioned.
Action: Do the checkout for the SLOW SCAN CONTROLLER BOARD A6 and COIL
BOARD A7.
Description: The system was not able to move to the position selected in the
diagnostics. The command is executed again.
Cause: The SLOW SCAN CONTROLLER BOARD malfunctioned.
Action: Do the checkout for the SLOW SCAN CONTROLLER BOARD A6 and COIL
BOARD A7.
Description: The system was not able to move to the position selected in the
diagnostics. The command is executed again
Cause: The SLOW SCAN CONTROLLER BOARD A6 malfunctioned.
Action: Do the checkout for the SLOW SCAN CONTROLLER BOARD A6 and COIL
BOARD A7.