Konica Minolta 7045 - Chapter............................................................................................................ 10-3 Combination; Sheet;Cover Insertion

Shortcuts 10-3
Shortcuts
Sheet/Cover Insertion (see p. 8-3)
1 Press [APPLICATION] to display the Application Selection Screen.
2 Touch Sheet/Cover Insertion to display the Sheet/Cover Insertion Screen.
3 Touch TRAY1 or BYPASS to select the tray source for cover stock.
To insert thick paper for cover, touch THICK PAPER. BYPASS will automatically be
selected.
4 Select Front Cover Insertion, then touch FRONT COPY or FRONT BLANK.
5 Select Back Cover Insertion, then touch BACK COPY or BACK BLANK.
6 Select Sheet Insertion, then COPY INSERTION or BLANK INSERTION.
7 Touch OK to display the Page Setting Screen.
8 Touch the 15 blank boxes in turn to designate each insertion location.
9 Touch SET after each entry.
10 When all page numbers are entered, touch OK.
11 Enter the print quantity amount.
12 Position originals face up on the document feeder tray.
13 Press [START]. When copying is completed, press [AUTO RESET] to reset the machine.
Chapter (see p. 8-8)
1 Press [APPLICATION] to display the Application Selection Screen.
2 Touch Chapter to display the Chapter Page Setting Screen with 1-2 mode
automatically selected.
3 Use the keypad to enter the page number of the first title page, then touch SET.
4 Repeat Step 3 for each additional title page, touching SET after each entry.
5 Touch OK to return to the Application Selection Screen.
6 Make additional copying selections, or touch OK to return to the Basic Screen.
7 Enter the print quantity amount.
8 Position (up to 50) originals face up on the RADF (document feeder) tray.
9 Press [START]. When copying is completed, press [AUTO RESET] to reset the machine.
Combination: Copy 2, 4 or 8 originals on 1 sheet (see p. 8-10)
1 Press [APPLICATION] to display the Application Selection Screen.
2 Touch Combination to display the Combination Mode Selection Screen.
3 Touch 2 in 1, 4 in 1, or 8 in 1.
4 Touch OK to return to the Application Selection Screen.
5 Make additional copying selections.
6 Touch OK to return to the Basic Screen with AMS automatically selected. You may
change this setting.
7 When all settings are correct, enter the print quantity amount.
8 Place original(s) face up on the RADF (document feeder) tray.
9 Press [START]. When copying is completed, press [AUTO RESET] to reset the machine.