Troubleshooting
13-6 Troubleshooting
Memory Overflow (continued)
Action 1
Action 1 is required when a job prematurely stops after the machine produces one
copied set and Memory overflow messages display alternately. Action 1 enables you to
continue the job (see procedure below) or suspend the job (see procedure at the bottom
of the page). Check the discharged copied set to see if the acquired scanned data is
sufficient for you to continue the job in the print quantity remaining.
To continue the job:
1 Press [START] to allow the machine to prepare the scanned data for job completion
in the amount remaining in the print quantity setting. When preparation of the
scanned data satisfies the print quantity setting, the machine will stop, and scanned
data will be erased.
(If the Staple mode had been selected for the job, it will be changed to Sort mode,
automatically.)
The following messages display, alternately:
If continuous working
check output after copying
- Memory full - Start => START key
Cancel => ST/CL key
(Alternately displayed)
2 Check pages of the discharged set to confirm the amount of missing data, before
completing the job.
3 Press [START] to complete the job according to the print quantity remaining.
To suspend the job:
1 Press [STOP/CLEAR] to save the job settings.
Or, press [AUTO RESET] to clear the job and resume initial settings.
All scanned data will be erased.
To Next Page