Machine Information 3-11
Machine Information
Service Settings
The following functions can be provided by your Konica service representative, who is
authorized to change DIP switch settings. Contact your service representative if setting
change is required.
Key Operator Password
Service can set a 4-digit Key Operator Password to limit access to the Key Operator
Mode. When this setting is on, a Password Entry Screen prompts the user to enter a 4-
digit password to access the Key Operator Mode Screen.
ECM Master Key Code
Service can set an 8-digit ECM Master Key Code to limit access to the ECM Setting
Menu Screen. When this setting is on, an ECM Master Key Code Screen prompts the
user to enter the 8-digit code to access the ECM Setting Menu Screen.
Weekly Timer Master Key Code
Service can set a 4-digit Weekly Timer Master Key Code to limit access to the Weekly
Timer Setting Menu Screen. When this setting is on, a screen message prompts the
user to enter a 4-digit code to access the Weekly Timer Setting Menu Screen.
Display Messages: ADD TONER/PM CALL
Service can set the message area of the copier screen to display “ADD TONER” when
toner supply is low, or “PM CALL” when preventive maintenance is required.
Staple Sheet Capacity
Staple capacity in the normal mode is changeable, and may be set to 45, 40, or 35 by
service. (default setting: 50)
Staple capacity in the thick paper mode is changeable, and may be set to 25, 15, or 10
by service. (default setting: 20)
Original Count Display
Service can set the Job No. icon on the touch screen to display the page count while
scanning originals, and also the page number currently printed when printing job starts.
To Next Page