Konica Minolta 7045 - Paper Exit Switching of Finisher Tray; Paper Exit Switching of Finisher Tray in Staple-Sort Mode; ADVANCE & DELETE Keys on Job List Screen; ECM Password Entering after Setting Reserve Job

3-12 Machine Information
Machine Information
Service Settings (continued)
Paper Exit Switching of Finisher Tray
When the amount of copies delivered onto the Finisher tray (upper, middle or lower)
exceeds its limit, the copier automatically shifts the output to another tray to complete
the output job. If you desire to release this function, contact your service representative.
See p. 7-3.
Paper Exit Switching of Finisher Tray in Staple-Sort Mode
When the amount of copies exceeds 25 sets in Staple-sort mode, the copier
automatically shifts the output from the Finisher middle tray to the lower tray, to complete
the output job. If you desire to use this function, contact your service representative.
ADVANCE & DELETE Keys on Job List Screen
The copier initially displays ADVANCE and DELETE keys on Job List Screen. Service
can make these keys appear grayed out on the screen.
ECM Password Entering After Setting Reserve Job
If ECM is activated on your copier, the copier starts the reserve job only when entering
your 5-digit ECM password using the keypad, after setting the reserve job.
If you desire to use this function, contact your service representative.
Control Panel Contrast Key in Help Screen
Service can set the copier to display Control panel contrast key on the Help Screen to
display the Contrast Adjustment Screen for adjusting panel contrast.