5-6 Copier Management
Copier Management
Weekly Timer Function (continued)
2 Use the keypad on the control panel to enter the 4-digit timer interrupt password.
If an invalid password is entered, continue by entering the valid 4-digit password.
Timer interrupt mode
Enter password ✻✻✻✻
3 Press [START].
Input copy time
0 hour(s) 05 minute(s)
4 Use the keypad to enter the hours in 1 digit. For example, enter [3] for three hours.
5 Press [START].
Your copy time is
3 hour(s) 05 minute(s)
6 Use the keypad to enter the minutes in 2 digits. For example, enter [0] [7] for seven
minutes.
Your copy time is
3 hour(s) 07 minute(s)
7 Press [START].
Copying is available until the set time is up.
Align original on RADF unit
When the timer interrupt job is finished, press [POWER SAVER ON/OFF]. The copier
returns to the OFF condition and copying is again disabled.
To Next Page