6-32 Basic Operations
Basic Operations
Interrupt Mode (continued)
3 Remove any document from the platen glass or from the document feeder, if
present.
4 Place new original(s) FACE DOWN on the platen glass or FACE UP in the document
feeder.
5 The copying settings in Interrupt mode are as follows.
Copy Mode : 1-1
RADF : ON
AES : ON
Lens Mode : 1.00 (100%)
APS : ON
Print Quantity : 1
Finisher : OFF*
Output mode for machine without Finisher : Sort
*: The copier with Finisher will output copies on the Finisher lower tray.
Select other copying features that are compatible with the Interrupt mode, if desired.
6 Press [START].
7 When Interrupt copying is completed, press [INTERRUPT] again to return to the
settings of the initial job.
8 Replace the initial original, then press [START] to resume copying.
NOTE:
1 In Reserve mode, pressing [INTERRUPT] before the copier finishes scanning the reserve job originals
clears the settings selected for the reserve job.
2 When [CHECK] is pressed during Interrupt Copying, the information displayed reflects the initial copy job
settings. Check mode will not display Interrupt copy job information.
To Next Page