Output Modes
Output Modes 7-5
Non-Sort Mode (continued)
1 Press [OUTPUT] to display the Output Mode Screen.
2 Touch TRAY1, TRAY2 or TRAY3.
To use the Non-sort mode, be sure the SORT, STAPLE, GROUP, and Face Up TRAY1
are not highlighted.
3 Touch OK to complete the setting and return to the Basic Screen.
4 Select additional copying features, as desired.
5 Enter the desired print quantity.
6 Position original(s) FACE UP in the document feeder or FACE DOWN on the platen
glass.
7 Press [START] to begin copying in Non-sort mode.
Copies will exit face down, with the page heading toward the front of the copier.
NOTES:
1. When the print quantity selected exceeds the finisher capacity, the copier automatically stops printing
before the number of discharged copies exceeds the capacity. Remove the copies from the tray, then press
[START] to complete the job.
2. When the Finisher is disconnected from the copier before printing, the message “Please connect finisher to
the copier” will be displayed, and if it happens to be disconnected in the middle of printing, the Jam Position
Screen will be displayed. Be sure to lock the Finisher securely to the copier to avoid the above cases.
To Next Page