Output Modes
Output Modes 7-7
Sort Mode (continued)
1 Press [OUTPUT] to display the Output Mode Screen.
2 Touch TRAY2 or TRAY3.
NOTE: When using the sort mode do not touch TRAY1.
3 Touch SORT.
4 Touch OK to complete the setting and return to the Basic Screen.
5 Select additional copying features, as desired.
6 Enter the desired print quantity.
7 Position originals FACE UP in the document feeder. 50 originals can be set.
When using RADF memory copy, position originals FACE UP in the document
feeder and touch SCAN on the Basic Screen to scan.
When using Platen memory copy, position original FACE DOWN on the platen glass
and touch SCAN on the Basic Screen to scan.
8 Press [START] .
NOTES:
1. When the print quantity selected exceeds the finisher capacity, the copier automatically stops printing
before the number of discharged copies exceeds the capacity. Remove the copies from the tray, then press
[START] to complete the job.
2 When the Finisher is disconnected from the copier before printing, the message “Please connect finisher to
the copier” will be displayed, and if it happens to be disconnected in the middle of printing, the Jam Position
Screen will be displayed. Be sure to lock the Finisher securely to the copier to avoid the above cases.
CAUTION
To avoid injury when the Finisher middle tray moves up and down, DO NOT PUT your hand into the
two portions of the closing area.
To Next Page