Konica Minolta BIZHUB 226 - Changing or Deleting a Speed Dial Destination

Store Address
7
7-10 bizhub 226
7.2
% For details on the F code such as the SUB address and password, refer to page 4-3.
8 Use +, to select a setting item, and press the OK key.
% The SUB address and password can be specified using up to 20 digits.
% If [SUB, SID SETTING] is selected: Enter the SUB address and password, and press the Back key.
% When [MODEM SPEED] is selected: Use +, to select [33.6Kbps], [14.4Kbps], or[9.6Kbps], and
press the Back key.
% Repeat this procedure until all the required settings are completed.
9 Select [RETURN], and press the OK key.
This returns to the screen where a fax number can be entered.
10 Press OK.
This registers settings, and returns to the Store Address screen.
7.2.5 Changing or deleting a speed dial destination
1 Press the Utility key.
2 Use +, to select [DIAL REGISTRATION], and press the OK key.
3 Use +, to select [SPEED DIAL], and press the OK key.
4 Enter a target 3-digit speed dial number using the Keypad, and press the OK key.
5 Use +, to select [EDIT] or [DELETE], and press the OK key.
% If [EDIT] is selected, go to the next step.
% If [DELETE] is selected, the information registered in the One-Touch Dial Key is deleted, and the
display returns to the Store Address screen.
6 Change the destination name, fax number, F code (SUB address or password), or baud rate.
After all settings are completed, the display returns to the Store Address screen.
d Reference
For details on how to change each setting, refer to Steps 6 to 8 in page 7-7.