Konica Minolta BIZHUB 226 - Specifying Multiple Destinations (Sequential Broadcast Transmission)

bizhub 226 3-15
3.4 Specifying a destination
3
3.4.9 Specifying multiple destinations (Sequential broadcast transmission)
The original can be sent to multiple destinations by one operation. This function is referred to as a sequential
broadcast transmission.
The following methods are provided to specify multiple destinations.
- Entering a dial number
- One-touch Dial
- Speed dial
- Group dial
- Address Book
Tips
- To send a fax to multiple destinations, use the Memory TX function.
- Up to 255 destinations can be specified at one time. When using a One-Touch Dial Key, up to 32 des-
tinations can be specified. When using Speed Dial, up to 250 destinations can be specified. When en-
tering a fax number, up to 16 destinations can be specified.
When necessary, you can combine the methods above to specify destinations.
1 Load the original.
% For details on how to load the original, refer to page 3-5.
2 Press the Function key.
3 Use +, to select [BROADCAST], and press the OK key.
4 Specify a destination, and press the OK key.
% When using a One-Touch Dial Key: Press the One-Touch Dial Key of a destination.
% When using Speed Dial: Press the Speed Dial key, and enter a 3-digit speed dial number of a des-
tination.
% When using Group Dial: Press the One-Touch Dial Key assigned to a destination group.
% When using Address Book: Press AddressBook to select [LIST] or [SEARCH], and specify a desti-
nation. For details, refer to page 3-13.
% When entering a fax number: Enter a destination fax number.
% If an optional Image Controller IC-209 or Network Card NC-504 is installed on this machine, Ad-
dress Search is available. For details, refer to page 5-5.
5 To add the destination, select [ADD], then press OK.
% Repeat Steps 4 and 5 to specify all destinations.
6 When necessary, specify a desired option for [QUALITY].
% For details on [QUALITY], refer to page 3-7.
7 Press the Start key.
This starts scanning and sending.
Tips
- A result report is printed out after sending is completed; therefore, you can check whether a fax is sent
to all destinations.
- To stop sending, press the Clear/Stop key, and select [YES] in the displayed screen. This cancels all
the selected destinations.
DESTINATION
BROADCAST