bizhub 226 7-21
7.4 Fax TX setting
7
7.4 Fax TX setting
Configure various transmission settings for fax communication.
7.4.1 Fax TX setting items
d Reference
Fax TX settings can also be configured using LSU (Local Setup Utility). For details, refer to page 11-4.
If an optional Image Controller IC-209 or Network Card NC-504 is installed on this machine, settings can
also be configured using PageScope Web Connection. For details, refer to PageScope Web Connection
- [Address] - [Fax Configuration] of [User's Guide Network Administrator].
7.4.2 Specifying the scanning density
1 Press the Utility key.
2 Use +, to select [FAX TX OPERATION], and press the OK key.
3 Use +, to select [DENSITY LEVEL], and press the OK key.
4 Use *) to select the density, and press the OK key.
This returns to the fax TX settings screen.
No. Fax TX setting Contents
1 [DENSITY LEVEL] Select the default density to scan the original from five levels. When
the paper color (background color) is darker, adjust to the light side.
When a text is faint or colored, adjust to the dark side.
2 [QUALITY PRIORITY] Specify the default image quality (resolution) to scan the original with
a combination of [STD/TEXT], [FINE/TEXT], [S-FINE/TEXT],
[STD/PHOTO], [FINE/PHOTO], and [S-FINE/PHOTO].
• The factory default is [STD/TEXT].
3 [DEFAULT TX] Select the default transmission method from [MEMORY TX] and [ADF
TX].
• The factory default is [MEMORY TX].
Tips
This setting is displayed when optional Reverse Automatic Docu-
ment Feeder DF-625 is installed.
4 [HEADER] To specify whether to add a header (transmission date and time,
sender name, sender's fax number, and other items) when transmit-
ting a fax, select [ON] or [OFF] as the default.
• The factory default is [ON].
Tips
This setting item may not be displayed in some regions.
5 [CONFIRM FAX NO.] When specifying a fax destination with direct input, a screen appears
prompting you to enter the fax number again for confirmation. Enter-
ing the fax number twice prevents one from entering incorrect desti-
nations. Select [ON] or [OFF] as needed.
• The factory default is [OFF].
To Next Page
Loading...
