Konica Minolta BIZHUB 226 - Setup Procedure; USB Connection; Network Connection

bizhub 226 6-5
6.1 Overview of PC-Fax
6
6.1.3 Setup procedure
The setup refers to a series of procedures for connecting this machine to the computer and installing the fax
driver to the computer.
Perform the setup using the following procedures.
Tips
- When updating an existing fax driver, uninstall it first. For details, refer to page 6-6.
USB connection
1 Connect this machine to the computer using a USB cable.
2 Install the fax driver.
d Reference
For details on the USB interface, refer to the [User's Guide Printer Operations].
Network connection
1 Connect this machine to the computer.
2 Check that the computer to be used is connected to the network.
3 Specify the IP address of this machine, and then connect it to the network.
4 Change the network settings for this machine according to the connection method or protocol.
% LPR: Select [TCP/IP Configuration] - [LPD Setting], and enable LPD printing.
% Port 9100: Select [IPv4 Configuration], and enable the RAW port number (default: [9100]).
5 Install the fax driver.
% Specify the network port for the fax driver according to the connection method or protocol.
d Reference
For details on Ethernet, refer to the [User's Guide Printer Operations].
For details on the network settings of the machine, refer to PageScope Web Connection - [Network] -
[TCP/IP Configuration] and [Network] - [IPv4 Configuration] in [User's Guide Network Administrator].