Ch.3 Sequence of Examination
< 73 >
REGIUS Console CS-3 OPERATION MANUAL Ver. 1.10 2005.2
3 Hold down the left mouse button and drag the font
size slider.
• Dragging the slider increases or decreases the font
size.
• Drag to the left to decrease the font size.
• Drag to the right to increase the font size.
4 Click the [OK] button or left-click the mouse in the
area other than annotation.
• When the [OK] button is clicked, returns to the
“Detailed Data Setting” (Overlay) screen after
rotating the annotation.
• When the area other than annotation is clicked,
switches the status to the one where the next
annotation can be allocated after the font size is
changed.
7) Changing the font size of allocated annotation
Procedures to change the font size of the allocated annotation
are described below. Font size can be changed within the
scope of 10mm ~ 100mm (0.4in ~ 4.0in).
1 Move the cursor over the allocated annotation.
• The cursor changes from the arrow to the cross.
2 Left-click the mouse.
• Cursor blinks over the selected annotation.
Unit of the font size
(mm or inch) shall be
set up by the service
engineer at the time of
installation.
Ex) Changing the size from 20mm to
30mm
3
4
2
To Next Page
Loading...
