KWB Easyfire - KWB Easyfire I;O Plug-In Module 1

Page 200 IM Easyfire 10/2008 © KWB – Kraft und Wärme aus Biomasse GmbH
18.3 Electrical diagrams
18.3 Electrical diagrams
KWB Easyfire I/O plug-in module 1 TDB-ELS-USP-EBAA1029_a
Eingeste llt
Ste cker-Nr. Heizkre is/Zweitkesse l Saugsyste m/Zwei tkesse l
51 VL-Fühler HK 0 Kesselfühler-Zweitkessel
52 Fernversteller HK 0 -
53 Kesselfühler-Zweitkessel -
54 - -
55 Thermostat-Zweitkessel Thermostat-Zweitkessel
56
Rauchg.thermostat-
Zweitkessel
Rauchg.thermostat-
Zweitkessel
57 - -
58 - -
59 HK-Pumpe 0 -
60 HK-Mischer 0
Saugturbine
Filterreinig.
61 Pumpe Zweitkessel Pumpe Zweitkessel
62
Versorgung
230 VAC
Versorgung
230 VAC
Softwarekonfiguration
Software configuration
Set

Connect.
no.
Heat. circuit /
second boiler
Suction system /
second boiler
51
FF – sensor HC 0
Boiler sensor –
second boiler
52
Remote thermostat HC 0 –
53 Boiler sensor – second
boiler
–
54
––
55
Thermostat, second boiler Thermostat, second boiler
56 Flue gas thermostat,
second boiler
Flue gas thermostat,
second boiler
57
––
58
––
59
HC pump 0 –
60 HC mixer 0
Suction turbine L 
Filter cleaning L 
61
Pump, second boiler Pump, second boiler
62
Supply 230 VAC Supply 230 VAC
Plug-in module 1
Attention!
If only the second boiler is
connected it must be connected
as specified for the pin assignment
suction system / second boiler!
You must tick the selected
pin assignment as part of the
connection task.
Configuration-specific plug-in connector pin assignment
KWB art. no.: 50014002
MA-Easyfire 10.2008_EN.indd 200MA-Easyfire 10.2008_EN.indd 200 30.03.2009 13:32:26 Uhr30.03.2009 13:32:26 Uhr