2 System installation
2.1.3 Changing the stop side of the boiler room door
Secure the burner room door in position!
Loosen the screws of the door holder.
Boiler room door – bolted connections
Unscrew the screws of the locking bracket.
Boiler room door – locking bracket
Turn the boiler room door 180°.
Mount the holding bracket on the opposite side of the boiler room door
frame.
Then fasten the locking bracket.
Mount the door handle on the boiler room door.
Use the holder and locking bracket to adjust the boiler room door until
it seals when it closes.
Boiler room door – install the door handle
Attention! Install the boiler room door in such manner that it seals when it closes. After
closing (sealing), when opening the door again you should see the continuous imprint of
the boiler room door frame all around the door perimeter on the sealing cord.
2.1.4 Boiler set-Up
The floor on the boiler area must be level and capable of bearing
a load.
The fire-safety requirements are specified under point 1.3.1.
Place 4 surface mats under the boiler (included in the scope
of delivery).
These mats prevent acoustic transmission to the floor.
Red surface mats
MA-Easyfire 10.2008_EN.indd 22MA-Easyfire 10.2008_EN.indd 22 30.03.2009 13:29:54 Uhr30.03.2009 13:29:54 Uhr
To Next Page
Loading...
Need help?
General
