12 Pellet Stirrer Plus
12.4 Mounting the extensions
3.) Remove the trough cover
Remove the cover for fuel extractors with trough extension.
4.) Prepare the bore of the first intermediate bearing
Enlarge the prepared small bore for fastening the intermediate bearing
to a Ø of 10 mm.
Attention:
For extension KWB art. no. ZSV 24 a second intermediate bearing must
be set (see drawing MBDK0001 in the attachment)
Seal bores that are not required with the supplied bolt.
5.) Mount the intermediate bearing
Mount the intermediate bearing and align it so that is flush. The collar of
the bearing should point in the direction of the bearing.
The free shaft end must still be supported at axis height until the
intermediate bearing is fastened in the trough.
6.) Seal the flange connection
Apply a small, continuous bead of silicon on the facing side of the flange
before joining the elements together.
7.) Bolt the flange
Bolt the two troughs together so that they are flush.
MA-Easyfire 10.2008_EN.indd 117MA-Easyfire 10.2008_EN.indd 117 30.03.2009 13:31:02 Uhr30.03.2009 13:31:02 Uhr
To Next Page
Loading...
